In addition, the black dust was found in most of the heat registers. He could rub it off on his fingers but did nothing but spray compressed air on it which didn’t make it disappear since it wasn’t loose. Also, in the register in the basement he described the black dust as being oily. The reality of that situation is that I had the AC on until the morning of the service and minutes after he snaked the hoses in my back door it started raining. The basement register had condensation from the humidity all over it. It was not oily but wet. He asked for an old towel and wiped it out. Never saw anything so black – because I never had to clean soot. That is what I have in my ducts. Soot from years of the old coal furnace.
I moved into a house built in 2003 last year, and spent a lot of time researching air filters because I realize air pollution inside the house is many times higher than outside, and my health and the health of children and youngers can be so adversely impacted by inhaling these indoor pollutants. I spent a lot of money on the best filters because here in northern Kentucky, I discovered I am allergic to something in the air starting in Spring that made me sick for 10 days - sort of a Upper Respiratory Illness. It never occurred to me the previous owner had never cleaned the air ducts, although he had both very young children, two dogs and a cat.
Lowe's Air Duct Cleaning is an honest and reputable company, specializing in air duct and dryer vent cleaning business. We always stand behind the jobs we do and guarantee the best quality results for each project. Our prices are very competitive and detailed pricing is always disclosed upfront. It is our promise that our representatives will never use any "bait and switch" or other scamming techniques to increase the agreed upon price. We use source removal duct cleaning method, NADCA recommended cleaning method, which guarantees that your ducts will be as clean as possible after our service. We even prove the cleaning results with a duct camera. Lowe's Air Duct Cleaning offers 100% satisfaction guarantee or your money back. Give us a call and you won't be disappointed. Let us prove why we are the BEST.
Demonstrate visible evidence of microbial growth in your duct work. Some service providers may attempt to convince you that your air ducts are contaminated by demonstrating that the microorganisms found in your home grow on a settling plate (i.e., petri dish). This is inappropriate. Some microorganisms are always present in the air, and some growth on a settling plate is normal. As noted earlier, only an expert can positively identify a substance as biological growth and lab analysis may be required for final confirmation. Other testing methods are not reliable.
After they left, I was feeling uneasy about the quality of work that was performed. I used a camera to get some video of the vents that they cleaned. They looked pretty good, but then I started to remember how they were cleaning them. They only used their large, commercial vacuum on one vent. They also did NOT clean 2 air returns under Negative Pressure like the Groupon said they would. I did a little research and found that they should have cut open an access point in duct work in the basement and sealed up the vents with plastic to create that negative pressure.
So I purchased a Groupon to have this service done on my HVAC. I waited like 3 weeks or so since I was not using the heat or AC and I was in no hurry. So, on the day of my scheduled appointment which was 12noon I get a call from their office at 12:05pm that they are running late and they are 2 hours away...How did they manage to end up 2 hours from my house? Odd. Anyway, the girl tells me that they can't make the appointment today and will have to reschedule 30 days from now. What? 30 days from now? I was expecting perhaps tomorrow or the next day, not 30 days from now. This is extremely poor customer service and poor time management. Their leadership team should be reprimanded or replaced. I don't know how this company can stay in business when their business practices are so disorganized and they cannot even manage a schedule efficiently. I would NEVER recommend this company when they treat the customers so poorly. Their front office person should be retrained or fired since she does not have the skills needed to deal with customers. I would go so far as to fire their Office Manager or perhaps the Manager of this company. Well, at least they did not show up and provide poor service as it appears they did in the other customer reviews.
Quality and price should come hand in hand, a too-good-to-be-true price for an efficient air duct cleaning will not give you the quality that you wanted. To make sure you are getting your money’s worth, check reviews of air duct cleaning companies, certifications from industry since this work requires continuous learning due to new techniques and research breakthrough from time to time. My mom is located in Arizona and they trust J&M Restoration air duct cleaning company, they have an A+ BBB rating, they used EPA approved sanitizing agents, their technicians are NADCA certified, and the company is certified by the Institute of Inspection, cleaning and Restoration. Make sure to shop around and get written estimates first.
The next step was cleaning the cold air returns. He found a good spot to drill an 8” hole for his vacuum hose. The procedure matched the other air ducts except that when he finished at the two cold return registers he drilled several holes in the cold ducts in the basement and blasted air into them. Because of our houses age and the upgraded return system, I noticed that the main sheet metal return duct had no top but was just butted up against the ceiling in the basement. When he blasted air in, dust and crap shot out the edges along the ceiling. Once he finished that he removed the filter and “swept” out anything at the bottom of the return with his hand into the 8” hose.
According to National Fire Protection Association in 2010, an estimated 16,800 reported U.S. non-confined or confined home structure fires involving clothes dryers or washing machines resulted in 51 civilian deaths, 380 civilian injuries and $236 million in direct property damage. (http://www.nfpa.org/safety-information/for-consumers/causes/dryers-and-washing-machines)
#3 The ONLY time Duct cleaning is needed is when the home had a fire, Bad roof leak on to FIBERGLASS ductwork or house sat vacant for many years with out the air running. And its better to replace than to do “abrasive” duct cleaning. If the duct cleaning has a rotating brush it will remove part of the glue that is holding the Fiberglass in the ducts together, PERIOD no matter how much the say it don’t because the brush is soft.
The same holds true for the evaporator coils inside your home’s cooling system. Evaporator coils cause condensation, dehumidifying the air before it circulates through your home. Condensed moisture can cause dust and other particles to stick to and build up on the coils. Also, cleaning the collector pan (and the drain spout in the pan) beneath the coils ensures dirt doesn’t build up and get drawn into the system. It also prevents water from accumulating on and beneath the coils, which can cause mold problems.
If you or someone in your family suffers from asthma or allergies, you may be considering getting your home’s heating and cooling ducts cleaned. But even if you have no special health concerns, cleaning your ducts may appeal to you at an intuitive level. After all, if your ducts are clean, all that air flowing out of your vents should come out clean, too, right?
The original furnace was a coal fired “octopus” design which had no blower to circulate the air but relied upon warm air rising to distribute the heat. That also means that the system breathed air in from the basement and most of this type did not have a cold air return system. At some point (probably in the 1940’s) the system was upgraded to a forced air gas furnace. The upgrade included replacing the 12″ diameter air ducts exposed in the basement with 6″ ducts and a cold air return system of ducts from the two (only two) air returns on the first floor.
If you are replacing your air conditioning system, make sure that the unit is the proper size for your needs and that all ducts are sealed at the joints. A unit that is too big will cycle on and off frequently, resulting in poor moisture removal, particularly in areas with high humidity. Also make sure that your new system is designed to manage condensation effectively.
Pay particular attention to cooling coils, which are designed to remove water from the air and can be a major source of moisture contamination of the system that can lead to mold growth. Make sure the condensate pan drains properly. The presence of substantial standing water and/or debris indicates a problem requiring immediate attention. Check any insulation near cooling coils for wet spots.
And if you have flex duct and/or fiberglass ductboard in your home- the last thing you want is a big brush or anything abrasive running through it. Even high-pressure air can erode ductboard so I wouldn’t clean it with anything. If it becomes contaminated, get rid of it and install real ductwork. If your ductwork is accessible in the basement – the best thing to do is take it down and manually clean it if it’s full of junk. It’s not going to cost a nickel more to do that than to pay $500-1000 for a ‘duct cleaning machine” AKA big blower and vacuum – to do the job.
In addition, the service provider may propose applying chemical biocides, designed to kill microbiological contaminants, to the inside of the duct work and to other system components. Some service providers may also suggest applying chemical treatments (sealants or other encapsulants) to encapsulate or cover the inside surfaces of the air ducts and equipment housings because they believe it will control mold growth or prevent the release of dirt particles or fibers from ducts. These practices have yet to be fully researched and you should be fully informed before deciding to permit the use of biocides or chemical treatments in your air ducts. They should only be applied, if at all, after the system has been properly cleaned of all visible dust or debris.